CMC 52100 PT35 TILT & TRIM WITHOUT GAUGE

52100 CMC PT-35 ELECTRIC HYDRAULIC TILT TRIM WITHOUT GAUGE A smaller and lighter tilt and trim unit. It will accommodate clamp on or bolt on, 35 h.p. and smaller motors without the need of an adapter. It incorporates the same powerful actuator as the PT-130 and weighs only 24 lbs.! See limitations below. It incorporates a 5-1/2" setback, which enhances boat stability and enables the prop to get a better bite at a higher prop setting. With the touch of a switch you can raise your motor to protect your prop from damage and your back from strain. It has a total of 84° of trim and tilt. It allows you to tuck your motor in to get your boat on plane smoother and faster. When you’re underway, you can change the angle of your motor to obtain the best performance for your load and water conditions. It gives you a more stable ride, increases top end speed, more prop clearance and better fuel efficiency. It is also more impervious to saltwater and freshwater than other brands because it is made of 100% non-ferrous materials. * Limitations: The inside dimensions of the motor mounting area of the PT-35 is 10". Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 10" limit. Four mounting bolts will be required to mount the PT-35 to the transom of the boat. Because of numerous transom thickness’, mounting bolts are not included.